Verify the MDI and PC are within range of the Access Point or Router.

Confirm LEDs on the wireless card are lighted when the MDI is powered. Check the wireless card is properly seated in the WiFi GM MDI. GM MDI Manual: What if MDI fails to connect on Wireless You can contact your IT department and check that your PC is detecting the wireless access point and the correct security settings have been configured for the MDI. Then what you need to check is that the USB cable is not plugged in, the MDI is not being used via wired ethernet and the wireless card is properly seated in the MDI. If you connect them by wireless ethernet, you should make sure that wireless communication is enabled and the IP configuration is properly set using the MDI Manager software. Try connecting to other USB ports on the PC. NDIS Network Device’ under Network Connections).

Verify the USB driver has been installed on the PC (look for device name ‘ETAS USB Remote Verify that only one MDI is connected to your PC using USB. Verify a USB Hub is not being used (MDI has a fixed USB address). GM MDI Manual: What if MDI fails to connect on USB If it is not running, check all USB ports on the PC and verify that the MDI is powered on. Then check for the device name ETAS USB Remote NDIS Network Device. Open the Network and Dial-up Connections Window from the Windows Control Panel. About the solutions, you can connect the MDI to the PC USB port and power up the MDI. Part 4: Tech support: GM MDI not connectingĪnd if you connect them by USB, you need to check the MDI USB connection is detected by windows. Part 3: GM MDI connection by wired ethernet Part 2: GM MDI connection by wireless ethernet mdi connection can be discussed in the following 4 parts:

If the MDI can not communicate with the MDI, you should check the cables if they are securely attached to the MDI, if the MDI has completed its power up sequence, if the connector pins are clean and if the MDI Manager software is running. If the USB is available, the MDI will connect by using the USB and if not, the MDI will connect by using wired ethernet and if neither of them is available, the MDI will connect by using wireless. Here are all solutions aimed to help fix GM MDI multiple diagnostic interface connection/communication issues (connection by usb, wireless ethernet, wired ethernet)… big thanks to all contributors and įirst, you should make sure that the MDI Manager software should be installed on the PC and the MDI must be powered up before you use it to communicate.Īlso the MDI should be configured for wired ethernet or wireless communication.

Gm tech 2 software for windows usb